a. Remove setscrew (9) from housing (16).
b. Screw 1/8" -24 machine screw into end of check
flash point is 100F-138F (38-59 C).
ball seat (11). Pull screw and seat (11) out with
If you become dizzy while using
cleaning solvent, get fresh air
immediately and get medical aid. If
Remove and discard seals (10) and (12) from
contact with eyes is made, wash your
eyes with water and get medical aid
Dry parts with
d. Tip housing (16) and remove check ball (13) and
compressed air. Do not wipe dry with
check ball retainer (14).
cloth or paper towel because lint or
other matter can get into hydraulic
Compressed air used for cleaning
purposes will not exceed 30 psi. Use
only with effective chip guarding and
Dry cleaning solvent P-D-680 is toxic
(goggles/ shield, gloves, etc.).
goggles and gloves and use only in a
well ventilated area. Avoid contact
1. CLEAN ALL PARTS WITH SOLVENT P-D-680 AND
with skin, eyes, and clothes and do
BLOW DRY WITH COMPRESSED AIR.
not breathe vapors. Do not use near
open flame or excessive heat. The