TM 5-3810-306-34
c. Remove capscrews (43) and (44), and valve
section (42) from valve body (10).
get fresh air immediately and get
medical aid. If contact with eyes is
d. Remove and discard packings (35), (36) and
made, wash your eyes with water and
(37).
get medical aid immediately.
e. Remove plug (7) and packing (8) from valve
Compressed air used for cleaning
section (9). Discard packing (8).
purposes will not exceed 30 psi. Use
only with effective chip guarding and
f. Remove directional sleeve (3) from valve section
personal
protective
equipments
(9).
(Goggles/shield, gloves, etc.).
g. Remove and discard packings (4), (5) and (6).
1.
CLEAN ALL PARTS IN SOLVENT P-D-680 AND
BLOW DRY WITH COMPRESSED AIR.
h. Remove relief valve (41) from valve section (42).
INSPECTION:
i. Remove directional sleeve (45) from valve
section (42).
1.
INSPECT ALL PARTS FOR WEAR OR OTHER
DAMAGE.
j. Remove and discard packings (47, (48) and (49)
from directional sleeve (45).
2.
CHECK THAT ALL ORIFICES ARE CLEAR.
k. Remove plugs (38) and (39), and packing (40)
ASSEMBLY:
from valve section (42).
CAUTION
4.
IF NECESSARY, REMOVE PLUG (22) FROM
VALVE BODY (10).
Install new packings on or in all
component parts.
Coat packings
CLEANING:
with clean hydraulic oil prior to
assembly.
WARNING
CAUTION
Dry cleaning solvent P-D-680 is toxic
and flammable.
Wear protective
Do not damage the packings during
goggles and gloves and use only in a
installation of the valve. If the valve
well ventilated area. Avoid contact
turns freely then gets hard to turn,
with skin, eyes, and clothes and do
then easy to turn; remove the valve
not breathe vapors. Do not use near
and check the packings. They have
open flame or excessive heat. The
probably been damaged by a sharp
flash point is 100F-138F (38-59C).
edge of a port or thread.
If you become dizzy while using
cleaning solvent,
WARNING (CON'T)
13-54