TM 5-3810-306-34
b. Tighten bolt (3) until all free play is removed from
e. Install retaining nut (9) and torque to 35 ft-lbs (47
Nm).
c.
Use pry bar to check drum (32) for free play.
f.
Install keywasher (10) and locknut (8). Torque
locknut (8) to 20 ft-lbs (27 Nm).
d. Using feeler gauge, measure clearance between
planet cage housing (23) and bearing retainer
g. Lock locknut (8) by bending tab of keywasher
(20).
(10) into corresponding groove of locknut.
e. From this reading subtract 0.005 in. (0.127 mm)
h. Install new preformed packing (6) on left end
to find amount of shimming needed to ensure
cover (5).
i.
Apply Loctite #242 to the hex head bolt threads
f.
Remove bearing retainer (20).
(3).
g. Install shims (22) with measurement equal to
j.
Install left end cover (5) on planet cage housing
that computed in Step e.
(23) using hex head bolts (3). Torque hex head
bolts (3) to 31 ft-lbs (41 Nm).
h. Apply Loctite #242 to the hex head bolt threads
(3).
11. SERVICE FINAL DRIVE.
i.
a. Remove fill/check plug (27) from side of final
(21) and hex head bolts (3). Torque to 31 ft-lbs
drive assembly.
(41 Nm).
b. Fill with 90 weight EPGL gear lubricant until oil
10. INSTALL END COVER (5).
starts to flow out of plug hole.
a. Install the planet cage assembly (19).
c.
Install fill/check plug (27).
b. Install the pinion gear (14).
12. INSTALL HOIST BRAKE ASSEMBLY (REFER TO
c.
Install snap ring (13) on main shaft (33).
13. INSTALL HOIST MOTORS. (REFER TO PAGE 15-
d. Install thrust bearing housing (12) and ball thrust
bearing (11) so small ID of bearing will face
locknut (8).
14. INSTALL HOIST ASSEMBLY. (REFER TO PAGES
END OF TASK
15-48