a. Place cam ring assembly on a clean, flat
6. REMOVE SETSCREW (25), VALVE ADAPTER (24),
PACKING (13) AND RUBBER SEAL (14).
b. Push rotor and vanes from cam ring far enough
a. Remove special setscrew (25) in the side of port
plate assembly (12).
(9) and around rotor (8).
b. Remove valve adapter (24) from the drilled
vanes remainder of way out of cam ring.
d. Release tension on compressor and remove
vanes (9) and vane springs (10) from rotor (8).
The drilled holes in port plate must
be clean and free from burrs.
5. REMOVE PORT PLATE (12).
Remove packing (13), rubber seal (14) and
a. Remove dowel pin (11) from port plate assembly
Belleville washer (20). Discard packing (13) and
(12). Note location of dowel pin (11) in relation
to body (21) for reassembly.
7. REMOVE SHAFT (18).
b. Thread two 1/4-20 screws into puller holes in
port plate assembly (12) and remove it from
a. Remove snap ring (15) from body (21).