TM 55-8145-201-14
5-4. SIDE PANEL REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
General Mechanics Tool Kit (Item 4, App B)
Container Bolt (138) (Item 27, App F)
Portable Drill (Item 2, App B)
Container nut (138) (Item 26, App F)
Personnel Required:
Two
References:
TM 9-4110-252-14
TM 5-6115-585-12/34
Material/Parts:
Equipment Condition :
Pop Rivet (38) (Item 28, App F)
Refrigeration unit shutdown (TM 9-4110-252-14)
NOTE
Replacement of the right side panel is shown.
Replacement of the left side panel is similar.
a. Removal.
(1) Mark and record location of four angle plates (9, 10, 11 and 13).
(2) Using portable drill and drill bit, drill out rivets (14) from angle plates (11 and 13).
(3) Remove fourteen screws (15) and thirteen bolts (16) from angle plate (13).
(4) Remove sixty-two screws (8) from two floor angle plates (9 and 10).
(5) Carefully pry four angle plates (9, 10, 11 and 13) from side panel (3), front panel (12) and floor panel (6).
(6) Remove insulation (5) from space between side panel (3), front panel (12) and floor panel (16).
(7) Remove sealant tape (7) from edges of edge of floor panel (6).
(8) Using torx bit and socket, remove container nuts (2) and bolts (4) from top, bottom, and sides of side panel
(3).
WARNING
Floor panel is heavy/difficult to handle. Use two
personnel when installing floor panel.
(9) Connect hoist and sling to side panel (3).
5-8