TM 9-3950-253-13&P
0061
CLEANING INSTRUCTIONS - Continued
Oil Seals, Electrical Cables, and Flexible Hoses. Wash oil seals, electrical cables, and flexible hoses with
3.
a solution of Detergent, General Purpose, Liquid (WP 0120, Table 1, Item 7) and water, and wipe dry with a
clean Rag, Wiping (WP 0120, Table 1, Item 16).
END OF TASK
PRESERVATION OF PARTS
Unpainted metal parts that will not be installed immediately after cleaning may be covered with a thin coat of light
Oil, Lubricating (WP 0120, Table 1, Item 13).
END OF TASK
PAINTING
On painted areas where paint has been removed, paint in accordance with procedures outlined in TM 43-0139,
Painting Instructions for Army Materiel.
END OF TASK
INSPECTION INSTRUCTIONS
NOTE
All damaged areas should be marked for repair or replacement.
1.
All components and parts must be carefully checked to determine if they are serviceable for use, can be
repaired, or must be scrapped.
2.
Inspect drilled and tapped (threaded) holes for the following:
a.
Wear, distortion, cracks, and any other damage in or around holes.
b.
Threaded areas for wear, distortion (stretching), and evidence of cross-threading.
3.
Inspect metal lines, flexible lines or hoses, and metal fittings and connectors for the following:
a.
Metal lines for sharp kinks, cracks, bad bends, and dents.
b.
Flexible lines or hoses for fraying, evidence of leakage, and loose metal fittings or connectors.
c.
Metal fittings and connectors for thread damage and worn or rounded hex heads.
4.
Inspect castings, forgings, and vehicle metal parts for the following:
a.
Equipment surfaces for nicks, burrs, raised metal wear, and other damage.
b.
Inner and outer surfaces for breaks and cracks.
END OF TASK
0061-3
03/15/2011Rel(1.10)root(maintwp)wpno(M582060)