TM 10-3930-641-34-1
TIMING GEARS (FRONT OF THE ENGINE) SPECIFICSATIONS
(Sheet 1 of 1)
(1)
6N2532 Gear on the drive for the fuel injection pump.
(2)
7N8345 Gear for the engine valve camshaft.
NOTE
Make alignment of "V" mark as shown.
(3)
4N1948 Gear for the water pump.
(4)
7N7586 Idler Gear (small) and 4N868 Balance Gear (large).
NOTE
Make alignment "V" marks as shown.
(5)
Bore in the bearing
(new).................................... 2.5060 + .0014 (63.602 + 0.036 mm)
Diameter of the shaft
(new).............................. 2.5000 + .0005 in. (63.500 + 0.013 mm)
(6)
End clearance (new) ................ 006 to .014 in. (0.15 to 0.35 mm)
(7)
Plate. The lubrication groove must be against the gear.
(8)
Crankshaft gear 7N7591.
NOTE
Make alignment "V" mark as shown.
(9)
797592 Gear for the engine oil pump.
TA098804
(10)
Torque for bolt ......................................40 + 5 lb. ft. (54 + 7 N.m)
End
2-74