TM 10-3930-641-34-1
ENGINE FRONT SUPPORT AND TRUNNION REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 3)
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
Remove four capscrews so beam may be
installed.
1. Oil pan
WARNING
2. Support beam and four capscrews
Use extreme caution when installing jacking
device. Do not let jack, beam, or engine slip.
Serious injury could result.
3. Capscrews (1)
a. Install beam under oil pan.
b. Place hydraulic jack under center of beam.
Do not lift yet.
a. Loosen four at frame.
b.
Using hydraulic jack, raise engine until
support (3) is free of frame.
c. Remove capscrews (1).
4. Capscrews (2)
Remove.
5. Engine support (3)
Remove
3-4