TM 10-3930-641-34-1
ENGINE OIL FILTER AND COOLER BYPASS VALVES REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 3)
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
Coat with clean engine oil.
1. Crankshaft front wear sleeve, front seal
2. Seal pilot
Install in crankshaft front seal.
a. Position gasket on cylinder block.
3. Gasket, timing gear cover (1)
b. Install timing gear cover and secure with the
three capscrews (2) and three nuts (3).
4. Clip (4)
Secure to timing gear cover with capscrews.
5. Elbow (5)
a. Replace O-ring seal and gasket if necessary.
b.
Put in position and secure with the three
capscrews.
6. Heater hose clip (6)
Install and secure with capscrew to hold heater
hoses in position.
7. Sensor unit (7)
Connect wire.
8. Alternator bracket
Install.
TA099110
End
3-290
