TM 10-3930-641-34-2
STEERING CYLINDERS DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 6 of 6)
LOCATION/ITEM
ACTION
REMARKS
10.
Piston (16)
Install on rod (6).
11.
Nut (13)
a. Install.
b. Tighten using a torque multiplier.
NOTE
Torque nut to 1440 lb. ft. to 1760 lb. ft.
(1950 to 2390 N-m).
12.
Piston (16)
cylinder.
13.
Capscrews (18)
Remove guide bolts. Install four capscrews in
head and cylinder.
14.
Install, using a hydraulic press.
NOTE
Bearing must be 0.32 in. (8.13 mm) below out-
side surface of cylinder. Inside diameter of
(57.21-57.36 mm) after installation.
15.
Two seals (19)
Install one seal on each side of cylinder bear-
ing, using a seal driver. Install seals 0.06 in.
(1.52 mm) below surface of cylinder, with lip
of seal toward outside.
End
6-90