TM 10-3930-675-10-1
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
OPERATE LIGHTS, HORN, AND FRONT WINDSHIELD WIPER/WASHER
0005 00
NOTE
If the engine is not running, ignition switch must be in ON position for the lights and horn to work.
1.
Place ignition switch to ON position.
2.
Move accessory control lever FORWARD for LEFT directional signal and REARWARD for RIGHT directional signal.
3.
Lift up on accessory control lever to FLASH headlights.
4.
Push down on accessory control lever for HIGH BEAM headlights.
5.
Press button at the end of the accessory control lever for HORN operation.
6.
Rotate accessory control lever knob for front windshield wiper and push for windshield washer functions.
ACCESSORY
CONTROL LEVER
SHUT DOWN ENGINE
0005 00
1.
Apply the parking brake.
2.
Retract and fully lower boom.
3.
Place transmission control lever in Neutral (N).
4.
Allow the engine to run for 1/2 to 1 minute at idle.
CAUTION
DO NOT never turn master battery switch to OFF when the engine is running. Damage to voltage reg-
ulator may result.
5.
Stop the engine by turning ignition switch to 0 position.
6.
When mission is completed, wait at least 1 minute and place master battery switch in OFF position.
0005 00-25
