TM 10-3930-675-10-2
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
AIR TRANSPORT - CONTINUED
WARNING
Ensure that tabs on ramp are engaged into ramp seat holes in dolly wheel storage compartment. Fail-
ure to secure ramp properly may cause ramp to fall under weight of dolly wheel, causing injury to
personnel.
k. Raise boom until dolly wheels are off the ground. Remove dolly wheels from tophandler. Remove lower retaining pin
from each dolly wheel and lower tophandler until dolly wheels are on the ground. Remove upper pin from each dolly
wheel to allow it to be removed from tophandler.
CAUTION
To ensure tophandler does not contact underside of boom, exercise tilt function while rotating tophan-
dler. Failure to do so may damage tophandler and/or boom.
l. Rotate tophandler 90 degrees counterclockwise to operational position.
m.Raise boom to approximately 12 to 13 ft (3.66 to 3.96 m) height.
n. Raise boom support. Refer to Placing Boom Support in Transport Position in this work package.
o. Return cab to operational position. Refer to Placing Cab in Transport Position in this work package.
p. Shut down RTCH engine.
END OF WORK PACKAGE
0007 00-25/(0007 00-26 Blank)