TM 10-3930-675-10
0009 00-1
TROUBLESHOOTING INSTRUCTIONS
0009 00
GENERAL
NOTE
If an error code appears on drivers ECS display screen during operation, refer to WP 0020 00 for further
information.
1.
This chapter provides information for identifying and correcting malfunctions which may develop while operating the
RTCH-RT 240.
2.
The Troubleshooting Symptom Index in WP 0010 00 lists common malfunctions which may occur and refers you to the
proper page in WP 0011 00, Table 1 for a troubleshooting procedure.
3.
The Troubleshooting Symptom Index cannot list all malfunctions that may occur, nor all tests or inspections and correc-
tive actions. If a malfunction is not listed, or is not corrected by the listed corrective actions, notify your supervisor.
4.
If you are unsure of the location of an item mentioned in troubleshooting, refer to WP 0002 00 or WP 0004 00.
5.
Before performing troubleshooting, read and follow all safety instructions found in the Warning Summary at the front of
this manual.
6.
When troubleshooting a malfunction:
a.
Locate the symptom or symptoms in WP 0010 00 that best describe the malfunction.
b.
Turn to the page in WP 0011 00, Table 1 where the troubleshooting procedures for the malfunction in question are
described. Headings at the top of each page show how each troubleshooting procedure is organized: SYMPTOM,
MALFUNCTION, and CORRECTIVE ACTION.
c.
Perform each step in the order listed until the malfunction is corrected. DO NOT perform any maintenance task
unless the troubleshooting procedure tells you to do so.
EXPLANATION OF COLUMNS
The columns in WP 0011 00, Table 1 are defined as follows:
1.
SYMPTOM. Indicates fault that has occurred in system/equipment.
2.
MALFUNCTION. Indicates probable cause for fault symptom.
3.
CORRECTIVE ACTION. Indicates procedure to correct the problem.