TM 10-3930-675-10 0020 00-42 ERROR CODES - CONTINUED 0020 00 Table 4. Error Codes - Continued. ERROR CODE DISPLAY LAYOUT DRIVER ACTION ERROR CODE EXPLANATION VEHICLE LIMITATIONS 1332 Finish Mission Notify maintenance. Information/Maintenance No current detected at injector for cylinder #4 when voltage is turned ON Injector for cylinder #4 turned off. 1341 Stop Vehicle Shut engine off/on. If code clears, resume mission. If code remains, notify maintenance. Warning - Degraded Operation Severe loss of data from ECM No noticeable performance effects possible. Possibility of engine stopping or difficulty in starting engine. 1343 Stop Vehicle Shut engine off/on. If code clears, resume mission. If code remains, notify maintenance. Warning - Degraded Operation Microprocessor communica- tion error inside ECM No noticeable performance effectspossible. Mayencounter severe loss of power. 1346 Finish Mission Notify maintenance. Information/Maintenance Software error in ECM Possibly too short of time for ECM to power down, less than 30 seconds. 1352 Stop Vehicle Press RESET. Finish mission. Notify maintenance. Warning - Degraded Operation Low voltage detected at sensor Faulty power supply. Engine is degraded to no air setting. 1415 Stop Vehicle Check oil level. Press RESET. If error remains, notify maintenance. Finish mission. Stop Vehicle Immediately Oil   pressure   signal   indicates below critical threshold Reduced power and speed. 1419 Finish Mission Notify maintenance. Information/Maintenance Error  in  intake  manifold  pres- sure sensor signal detected by ECM Engine is degraded to no air setting. 1431 Finish mission Notify maintenance. Information/Maintenance Both idle validation off-idle and on-idle    signals    indicate    the same voltage reading None