Error Code 1145 - Coolant Temperature Sensor Circuit Failure - Continued

Error Code 1145 - Coolant Temperature Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_351

Error Code 1145 - Coolant Temperature Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_353

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
318

TM 10-3930-675-20-1 0020 00-8 ENGINE TEMPERATURE SENSORS AND CIRCUITS TROUBLESHOOTING - CONTINUED 0020 00 Table 2. Error Code 1145 - Coolant Temperature Sensor Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1145 - Coolant Temperature Sensor Circuit Failure - Continued a. Inspect sensor harness and engine ECU connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check sensor harness and engine ECU for dirt or moisture in or on connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 7. Place ignition switch in OFF position. Disconnect engine harness from coolant temperature sensor and disconnect sensor harness connector from engine ECU. Perform the following resistance checks: If engine harness requires replacement, notify SRA. a. Measure resistance from pin 2 of sensor harness connector to all other pins in connector. Resistance should be greater than 100k ohms. USE TEST LEAD KIT P/N 3822758 >100K OHMS

Privacy Statement
Press Release
Contact