TM 10-3930-675-20-1
0034 00-1
MECHANICAL OR HYDRAULIC STEERING FAILURE TROUBLESHOOTING
0034 00
THIS WORK PACKAGE COVERS
Error Code 317 - Right-Front Wheel Angle Cannot
Reach Set Point Value
Error Code 318 - Right-Rear Wheel Angle Cannot
Reach Set Point Value
Error Code 319 - Left-Rear Wheel Angle Cannot Reach
Set Point Value
Error Code 320 - Left-Front Wheel Angle Cannot Reach
Set Point Value
Error Code 321 - Right-Front Wheel is Not Calibrated
Correctly
Error Code 322 - Right-Rear Wheel is Not Calibrated
Correctly
Error Code 323 - Left-Rear Wheel is Not Calibrated
Correctly
Error Code 324 - Left-Front Wheel is Not Calibrated
Correctly
INITIAL SETUP
References
TM 10-3930-675-10
NOTE
Refer to WP 0004 00 for additional troubleshooting guidance, information, and illustrations that locate criti-
cal components.
Table 1. Error Code 317 - Right-Front Wheel Angle Cannot Reach Set Point Value Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 317 - Right-Front Wheel Angle
Cannot Reach Set Point Value
1. Check wheel for obstruction
that will not allow wheel to
reach set point value.
Remove any obstruction(s).
2. Check hydraulic pressure at
test points no. 3, 6, and 7 (WP
0186 00). Pressure should be
3045 psi (210 bar).
a. If hydraulic pressure is not as
specified,
notify
DS
Maintenance
to
replace
tophandler and steering pump
assembly.
b. If hydraulic pressure is as
specified,
notify
DS
Maintenance
to
replace
steering control valve.
