TM 10-3930-675-24-1
TROUBLESHOOTING PROCEDURES (NON-ERROR CODE) - CONTINUED
0007 00
Table 2. Electrical Troubleshooting Procedures (Non-Error Code) - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Backup Lights/Alarm Does Not Operate When
d. Replace damaged backup
Vehicle Placed in Reverse - Continued.
alarm (WP 0106 00).
4. Check backup lights/alarm Repair or replace damaged
wiring
harnesses
and harnesses or connectors (WP
connectors for damage.
0113 00).
5. Check voltage (24V) at XK5 a. If no voltage (24V) is found at
pin 1 and 7 with the ignition on
XK5 pin 1, remove relay 305
and the transmission control
and test (WP 0113 00).
lever placed in Reverse.
b. Replace damaged or faulty
relay (WP 0074 00).
c. If no voltage (24V) is found at
XK5 pin 7, check continuity of
wire A57 (WP 0048 00-45).
d. Repair or replace damaged
wires or connectors (WP 0113
00).
6. Check voltage (24V) at XK13 a. If no voltage (24V) is found at
pin 4 and 7 with the ignition on
XK13 pin 4, remove relay
and the transmission control
3011 and test (WP 0113 00).
lever placed in Reverse.
b. Replace damaged or faulty
relay (WP 0074 00).
c. If no voltage (24V) is found at
XK13 pin 7, check continuity
of wire A51 (WP 0048 00-45).
d. Repair or replace damaged
wires or connectors (WP 0113
00).
7. Check voltage (24V) at XK5 a. If voltage does not change,
pin 5 with the ignition on while
remove relay 305 and test (WP
switching transmission control
0113 00).
lever between Neutral and
Reverse. There should be
voltage (24V) when in Neutral
and no voltage (OV) when in
Reverse.
0007 00-32
