TM 10-3930-675-24-1
ENGINE TEMPERATURE SENSORS AND CIRCUITS TROUBLESHOOTING - CONTINUED
0021 00
Table 8. Error Code 1213 - Oil Temperature
Sensor Circuit Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1213 - Oil Temperature Sensor 1. Ensure ignition switch is in
Circuit Failure.
OFF position. Disconnect
engine harness from oil
pressure/temperature sensor
(WP 0094 00).
a. Inspect oil temperature Clean and repair connector(s) as
sensor and engine harness required (WP 0113 00).
connectors
for
dirty,
corroded, bent, broken, and
pushed back or extended
pins.
b. Check oil temperature
Remove dirt and moisture from
sensor and engine harness
connector. Replace missing or
for dirt or moisture in or on
damaged connector seals (WP
the connectors and for
0113 00).
missing
or
damaged
connector seals.
2. Place ignition switch in OFF
position and disconnect engine
harness from oil pressure/
temperature sensor.
3. Measure resistance from pin 4 If resistance is not as specified,
(or D) to pin 2 (or B) of oil replace oil pressure/temperature
pressure/temperature sensor. sensor (WP 0094 00).
Resistance should be 300 to
90k Ohms.
300-90K Ohms
USE TEST LEAD KIT P/N 3822917
0021 00-22
