TM 10-3930-675-24-2
TOPHANDLER HYDRAULIC SPREADER MOTOR REPLACEMENT - CONTINUED
0167 00
REMOVAL - CONTINUED
NOTE
Prior to removal or disconnection of drive chain, measure and record adjuster rod length as shown in
location diagram to ensure proper chain adjustment on installation.
5.
Measure and record chain adjuster as shown below.
6.
Loosen chain adjuster jamnuts (9).
CHAIN
9
ADJUSTER
RECORD
MEASUREMENT
7.
Remove chain (15) from drive sprocket (14).
8.
Remove four socket head screws (13), hydraulic manifold (11) with hoses, and O-rings (12) from spreader motor (10).
Discard O-rings.
NOTE
Note direction of screws securing spreader motor to mounting weldment for installation.
9.
Remove ten screws (16), washers (18), and nuts (19) securing spreader motor (10) to mounting weldment (17).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance
during procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this warning
may result in death or injury to personnel.
Spreader motor weighs approximately 150 lb (68 kg). Lifting device must have sufficient capacity
to lift motor. Failure to follow this warning may result in injury to personnel.
0167 00-4
