TM 10-3930-675-24-2
AIR CONDITIONER COMPRESSOR REPLACEMENT - CONTINUED
0266 00
REMOVAL - CONTINUED
8.
Remove four screws (15), washers (16), and bracket (11) from left front of engine.
10
9
11
12
13
14
3
18
17
15,16
4
6
INSTALLATION
NOTE
Perform step 1 to install bracket on engine.
1.
Install bracket (11) on left front of engine with four washers (16) and screws (15).
2.
Install A/C compressor (3) on bracket (11) with two washers (10), bolt (12), and new locknut (9). DO NOT fully tighten
locknut.
3.
Connect two A/C hoses (14) to A/C compressor (3) and tighten two fitting nuts (13).
4.
Position two belts (8) on A/C compressor (3) and pulley (7).
5.
Install support rod (6) yoke (17) on A/C compressor (3) with screw (18) and new locknut (4). DO NOT fully tighten
locknut.
6.
Rotate support rod (6) until belts (8) can be depressed no more than 1/2 in. (12.7 mm) at center of belts. Tighten two
jamnuts (5).
7.
Tighten locknuts (4 and 9).
NOTE
Install new tiedown strap as necessary.
8.
Connect A/C compressor (3) connector (2) to engine wiring harness (1).
NOTE
Any time A/C system refrigerant is evacuated, replace receiver/dryer.
9.
10.
END OF WORK PACKAGE
0266 00-3/(0266 00-4 Blank)