TM 5-3810-306-34
5. CONNECT
TWO
TAGGED
WIRES
TO
18. CONNECT FOUR TAGGED HYDRAULIC LINES TO
TEMPERATURE SENSOR (16).
TORQUE CONVERTER.
6. CONNECT THREE TAGGED WIRES 672, 673 AND
19. INSTALL
SHAFT
BETWEEN
674 TO ALTERNATOR (15).
TORQUE CONVERTER AND TRANSMISSION.
7. CONNECT THREE TAGGED WIRES 671, 676 AND
20. REMOVE CAPS OR PLUGS AND CONNECT TWO
677 TO STARTER (14).
HYDRAULIC LINES TO TORQUE CONVERTER
CHARGING PUMP (4).
8. INSTALL BATTERY CABLE TO STARTER (14).
21. CONNECT TWO WIRING HARNESS ELECTRICAL
9. INSTALL FUEL RETURN LINE (13) TO FUEL
CONNECTORS (3) ON RIGHT SIDE WALL IN
INJECTION PUMP. SECURE WITH CLAMP.
ENGINE COMPARTMENT.
10.
INSTALL FUEL LINE TO FUEL PUMP (12).
22. CONNECT FIVE HYDRAULIC LINES TO TWO
OPEN PETCOCKS AT FUEL FILTER.
SECTION PUMP (4).
11. MOUNT STARTER RELAY (10) ON FRAME STUDS
23. CONNECT SIX HYDRAULIC LINES TO THREE
AND SECURE WITH ATTACHING HARDWARE.
SECTION PUMP (1).
12. INSTALL FUEL PRESSURE DIFFERENTIAL
24. INSTALL RADIATOR AND SHROUD ASSEMBLY.
SWITCH (9) ON FRAME STUDS AND SECURE
(REFER TO TM 5-3810-306-20.)
WITH ATTACHING HARDWARE.
25. INSTALL ENGINE HOOD. (REFER TO TM 5-3810-
13. CONNECT GROUNDING CABLE
(8)
FROM
306-20.)
STARTER TO LEFT SIDE WALL.
26. INSTALL REAR DECK.
(REFER TO TM 5-3810-
14. MOUNT AIR GOVERNOR (7) ON FRAME STUDS
306-20.)
AND SECURE WITH NUTS AND LOCKWASHERS.
27. CONNECT NEGATIVE BATTERY CABLE
AT
15. CONNECT AIR LINE FROM AIR GOVERNOR (7)
SHUNT. (REFER TO TM 5-3810-306-20.)
TO AIR COMPRESSOR (27).
28. INSPECT ALL ENGINE/TORQUE CONVERTER
16. CONNECT TAGGED ELECTRICAL CONNECTORS
FLUID LEVELS. START ENGINE AND CHECK
TO ENGINE FROM DCA BOX (6).
FOR LEAKS. (REFER TO TM 5-3810-306-10.)
17. CONNECT BRAIDED STEEL LINE (5) TO AIR
29. BLEED HIGH PRESSURE FUEL LINES. (REFER
COMPRESSOR (27).
TO PAGE 5-8.)
END OF TASK
4-6
