TM 5-3810-306-34
INSPECTION
ASSEMBLY
WARNING
Dry cleaning solvent P-D-680 is toxic
1. INSTALL BUSHINGS (12) AND (22).
and flammable.
Wear protective
goggles and gloves and use only in a
well ventilated area. Avoid contact
WARNING
with skin, eyes, and clothes and do
not breathe vapors. Do not use near
Do not strike hardened steel parts
open flame or excessive heat. The
directly with a hammer. Personal
flash point is 100F-138F (38C-
injury from chips or splinters may
59C). If you become dizzy while
result.
using cleaning solvent, get fresh air
immediately and get medical aid. If
NOTE
contact with eyes is made, wash your
eyes with water and get medical aid
Ream bushings as necessary.
immediately.
a. If used, install axle shaft guide plate with mallet.
Compressed air used for cleaning
purposes will not exceed 30 psi. Use
b. Using suitable driver, install bushing (12).
only with effective chip guarding and
personal
protective
equipment
c. Using suitable driver, install bushings (22).
(goggles/ shield, gloves, etc.).
2. INSTALL BUSHING (3), RETAINER (24) AND OIL
1. CLEAN ALL PARTS WITH CLEANING FLUID P-D-
SEAL (23) IN END OF AXLE HOUSING.
REAM
680 TYPE II.
BUSHING AS NECESSARY.
2. INSPECT ALL PARTS FOR WEAR AND DAMAGE.
3. INSTALL WHEEL SPINDLES (17).
a. Inspect propeller shaft universal joints for
a. Lubricate retaining plate bores (two places) in
looseness or wear.
wheel spindle (17).
b. Inspect splines on yoke for cracks or broken
b. Install wheel spindle (17) on axle socket.
teeth.
c. Install retaining plate (20) with original shims
c. Replace driveshaft if previous conditions exist.
(16).
d. Inspect all bushings and replace as necessary.
CAUTION
Insure retaining plate (20) is square
with spindle bore while tightening
capscrews (1).
d. Install four capscrews (1) and washers (2).
Tighten each capscrew (1) alternately in small
increments.
8-4
