TM 5-3810-306-34
4. CLEAN OIL FROM THREADS OF HEAD (9). COAT
THREADS WITH NEVER-SEEZ (PASTE TYPE)
LUBRICANT.
5. IF EXISTING HEAD (9) AND BARREL (3) ARE TO
BE USED, PROCEED AS FOLLOWS:
a. Screw head (9) into barrel (3).
b. Using strap wrench, tighten head securely until
the setscrew holes align.
c.
Apply Loctite #271 to setscrew (2) and install
setscrew.
6. IF NEW HEAD (9) OR BARREL (3) IS TO BE USED,
PROCEED AS FOLLOWS:
a. Screw head (9) into barrel (3).
b. Using a strap wrench, tighten head securely.
c.
If necessary, drill 0.265-in. diameter hole 3/16-in.
(max) deep in head.
NOTE
Setscrew (2) when installed should
WARNING
be flush with barrel.
Do not use air pressure to cycle or
d. Clean drilled hole of chips and debris.
pressurize cylinder.
e. Apply Loctite #271 to setscrew (2) and install
8. PRESSURIZE AND CYCLE CYLINDER. CHECK
setscrew.
FOR PROPER OPERATION AND ANY LEAKAGE.
7. IF REMOVED, INSTALL CAP (4).
9. INSTALL AXLE LOCKOUT CYLINDER. (REFER TO
END OF TASK
13-91
