TM 5-3810-306-34
2. CONNECT NEGATIVE BATTERY CABLE AT
SHUNT. (REFER TO TM 5-3810-306-20.)
CAUTION
Extend the cylinder rod ends only
enough to align them with the holes
in the lift cylinder attach fitting.
3. INSTALL LIFT CYLINDERS.
a. Extend cylinder rod ends and lower boom
until ends align with holes in lift cylinder
attach fittings.
b. Use extreme pressure multipurpose
grease to lubricate rod end anchor shafts
(5) and install them.
c. Install the retainer blocks (4), washers (3),
and capscrews (2) securing rod end
anchor shafts to lift cylinder attach fitting.
d. Gradually slacken boom lifting device until
boom lift cylinders are supporting boom;
detach lifting device and rigging from
boom.
e. Remove lift cylinder blocking device.
4. CONNECT THE HYDRAULIC LINES TO THE
TELESCOPE CYLINDER AS TAGGED PRIOR
TO REMOVAL.
6. INSTALL THE BOOM FLOODLIGHT AND
HARNESS. (REFER TO TM 5-3810-30620.)
5. INSTALL PAT/LMI COMPONENTS.
(REFER
TO CHAPTER 14.)
7. CONNECT THE ELECTRICAL WIRES AS
APPLICABLE.
8. INSTALL THE AUXILIARY BOOM
NOSE.
(REFER T6 TM 5-3810-306-20.)
9. INSTALL HOOK BLOCK AND OVERHAUL
BALL. (REFER TO TM 5-3810-306-20.)
10. TEST FOR PROPER OPERATION.
END OF TASK
15-7
