TM 5-3810-306-34
6. INSTALL OVERRUNNING CLUTCH (64).
d. Apply Loctite #271 to oil seal (28) and install in
drum side of planet cage housing (23).
a. Install bearing spacer (47) on pinion (46).
8. INSTALL DRUM
(32)
AND
PLANET
CAGE
HOUSING (23).
NOTE
a. Using suitable lifting device install drum (32)
The direction of free rotation of the
over main shaft (33).
over-running clutch (64) should be
counter-clockwise.
b. Apply Loctite #242 to bolt threads (4).
b. Install overrunning clutch (64) on pinion shaft
c.
Install ring gear (7) in planet cage housing (23)
(46) and secure with key (58).
using bolts (4).
c.
Install keywasher (56) and locknut (57). Torque
d. Torque bolts (4) to 31 ft-lbs (41 Nm).
locknut (57) using a spanner wrench to 20 ft-lbs
(27 Nm).
e. Apply Loctite #242 to hex head bolt threads (25).
d. Lock locknut (57) by bending a tab of keywasher
f.
Using suitable lifting device mount planet cage
(56) into corresponding groove of the locknut
housing (23) on center housing (34) using hex
(57).
head bolts (25) and washers (26). Torque hex
head bolts to 150 ft-lbs (200 Nm).
7. ASSEMBLE PLANET CAGE (19).
g. Apply Loctite #242 to hex head bolt threads (24)
NOTE
and (41). Install cable reel (88) using hex head
bolts (24) and (41) and washers (26) and (42).
Lubricate the preformed packings,
Torque bolts to 150 ft-lbs (200 Nm).
seals and bearings with 90 weight
EPGL gear lubricant.
9. INSTALL BEARING RETAINER (20).
a. Apply Loctite #271 to oil seal (39) and install in
CAUTION
primary drive housing side of drum (32).
Tighten the bolts (3) only enough to
NOTE
remove the free play from the drum
support bearings. Over tightening
If the bearings (30) and (36) are being
could result in premature bearing
reused, install them on the side from
failure.
which they were removed.
a. Mount bearing retainer (20) using only three
b. Press bearings (30) and (36) on both ends of
bolts (3) in a staggered sequence.
drum (32).
c.
Press bearing race (29) into planetary side of
planet cage housing (23).
15-46
