TM 5-3810-306-34
c. Apply Loctite to threads of capscrews (17).
d. Install pressure plate (15).
d. Install capscrews (17) and torque to 75 ft-lbs
NOTE
(100 Nm).
There are seven brake stators
4. ASSEMBLE BRAKE DISCS (10).
(13) and six brake discs (10).
Two brake stators (13) are flat
a. Set housing face down.
and should be installed first
and last. The other five brake
b. Place one inch (25.4 mm) block in housing on
stators (13) are concaved.
piston to act as a spacer in aligning brake discs
Each should be installed with
and plates.
the hump side up.
c. Set overrunning clutch (4) in position in housing.
e. Install brake stator (13) and brake disc (10)
alternating until all stators and discs are
NOTE
installed. The last one should be a brake stator.
The pressure plate (15) is
f. Install backing plate (12).
thicker than the backing plate
(12).
15-67
