TM 9-3950-253-13&P
0117
INTRODUCTION - Continued
H
Below depot maintenance
D
Depot maintenance
NOTE
The "L" maintenance class is not included in column (4) of the MAC. Functions to this class
of maintenance are identified by work time figure in the "H" column of column (4), and an
associated reference code is used in the REMARKS column (6). This code is keyed to the
remarks and the SRA complete repair application is explained there.
Column (5) Tools and Equipment Reference Code. Column (5) specifies, by a number code, those common tool
sets (not individual tools), common Test, Measurement and Diagnostic Equipment (TMDE), and special tools,
special TMDE and special support equipment required to perform the designated function. Codes are keyed to
the entries in the tools and test equipment table.
Column (6) Remarks Code. When applicable, this Column (6) contains a letter code, in alphabetical order, which
is keyed to the remarks table entries.
Explanation of Columns in the Tools and Test Equipment Requirements
Column (1) Tool or Test Equipment Reference Code. The tool or test equipment reference code correlates with a
code used in column (5) of the MAC.
Column (2) Maintenance Level. The lowest class of maintenance authorized to use the tool or test equipment.
Column (3) Nomenclature. Name or identification of the tool or test equipment.
Column (4) National Stock Number (NSN). The NSN of the tool or test equipment.
Column (5) Tool Number. The manufacturer's part number.
Explanation of Columns in the Remarks
Column (1) Remarks Code. The code recorded in column (6) of the MAC.
Column (2) Remarks. This column lists information pertinent to the maintenance task being performed as
indicated in the MAC.
END OF WORK PACKAGE
0117-5/blank
03/15/2011Rel(1.10)root(macintrowp)wpno(A582098)
