DIFFERENTIAL AND BEVEL GEAR ASSEMBLY (CONT)
(Sheet 8 of 11)
a. Put GAA general purpose grease on side
of washer without oil groove.
b. Position washer in case plain half (49)
with oil groove side facing up.
Install on spider assembly.
Case plain half (49)
Install on case assembly as shown.
Be sure mark on housing aligns with mark on
Install to secure housing to case assembly.
Tighten each to a torque of 175 to 225 lb. ft.
(238 to 304 N-m).
Bearing cone (8)
a. Heat to maximum of 2750F (1350C).
b. Install on case plain half (49).
Go on to Sheet 9