ROLL-OVER PROTECTIVE STRUCTURE REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 7)
When capscrews are removed, steel plates will
Covers and panels
a. Remove capscrews (1) and rear panel (2).
b. Remove capscrews (3) and cover (4).
Remove nine capscrews (5) and right side
a. Holding steel plate in location (7), remove
b. Remove steel plate.
Remove capscrews (11) at bottom of
d. Remove cable held in place with capscrews
(8) at both the bottom and top of right
e. Remove support (10).
Disconnect wiring harness at terminals (9).