TM 10-3930-675-24-2
SERVICE BRAKE CONTROL VALVE REPLACEMENT - CONTINUED
0126 00
REMOVAL
1.
Loosen fitting nut (2) of each hydraulic hose (1) and disconnect hydraulic hoses.
NOTE
Note position of tee fitting, adapter fittings, and elbow fittings to aid in installation.
2.
Remove service brake control valve (5) from floor of cab.
3.
Remove tee fitting (3), adapter fittings (6), and elbow fittings (4) from service brake control valve (5).
2
1
3
1
4
5
4 6
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
Install elbow fittings (4), adapter fittings (6), and tee fittings (3) on service brake control valve (5).
2.
Position service brake control valve (5) on floor of cab.
3.
Connect hydraulic hoses (1) and tighten fitting nuts (2).
4.
5.
6.
7.
Start engine (TM 10-3930-675-10) and check for leaks.
8.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0126 00-2