The two self tapping screws
(13) in each end of oil transfer
interchangeable. Note which
end they are removed from for
a. Clean all parts in a strong solution of
laundry detergent in hot water.
Use only clean low pressure
compressed air. If available,
allow parts to air dry or wipe
with clean lint-free cloth.
b. Use compressed air to dry the parts after
rinsing in clean hot water.
1. INSPECT ROCKER LEVER COMPONENTS.
a. Inspect rocker lever for cracks and
excessive wear in bore and contact
1. ASSEMBLE ROCKER LEVER ASSEMBLY.
a. Screw adjusting screw (2) into rocker lever
b. Measure rocker lever bore.
and locknut (1) onto adjusting screw.
Max. dia. .878 in. (22.301 mm)
b. Place retaining ring (6), thrust washer (7)
and wave washer (8) on one side of rocker
c. Measure rocker lever shaft diameter.
Min. dia. .874 in. (22.199 mm)
c. Lubricate shaft with motor oil.
d. Inspect pushrod ball and socket for signs
d. Position levers on rocker shaft.
of scoring. Inspect for cracks where the
ball and socket are pressed into the tube.
e. Install remaining washers and retaining
clips on rocker shaft.
e. Inspect oil transfer tube for cracks and
f. Compress wave washers and thrust
washers and install rocker lever support