TM 10-3930-641-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
TOPHANDLER REMOVAL AND INSTALLATION - CONTINUED
0005 00
1.
Removal - Continued.
NOTE
For access to hydraulic and electrical connections, it will be necessary to climb up fender and stand on tire
(left side).
c.
Disconnect two hydraulic connections at tophandler. Cap or plug openings.
d.
Disconnect electrical connector.
e.
Remove two safety chains.
f.
Start engine.
g.
Back RTCH slowly and directly away from tophandler until forks are clear.
ELECTRICAL
CONNECTION
HYDRAULIC
SAFETY
CHAIN
CONNECTIONS
SAFETY
CHAIN
422-0055
422-0056
2.
Installation.
a.
Slowly approach tophandler, which is resting on an elevated support, such as a container.
b.
Insert forks into openings on tophandler.
c.
Inch RTCH forward until forks are fully inserted into tophandler.
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and hydraulic
system pressure has been relieved. Tighten all connections before applying pressure. Escaping hydraulic
fluid under pressure can penetrate the skin, causing injury or death to personnel.
d.
Shut down engine. Move hydraulic control levers through all positions to relieve hydraulic system pressure.
e.
Install and secure two safety chains.
f.
Connect electrical connector.
g.
Connect two hydraulic connections.
END OF WORK PACKAGE
0005 00-14