TM 10-3930-641-20
(Sheet 3 of 3)
FUEL INJECTION LINES REMOVAL AND INSTALLATION (CONT)
LOCATION/ITEM
REMARKS
ACTION
INSTALLATION
If new lines are used for replacement, then
remove identification tags from lines. Tags can
cause wear on injection lines.
1. Fuel injection lines (2)
Must be clean and dry.
a.
b. Position on engine and connect to correct
injection pumps and valve cover base
adapter(s).
Tighten nuts on lines to torque of 25-35
c.
lb. ft. (34-48 Nm).
Install.
2. Capscrews (1) that secure injection
lines to support bracket
See page 2-181.
Remove air by operating the priming pump.
3. Fuel system
End
2-172
