TM 10-3930-641-20
TIRE REMOVAL/INSTALLATION (CONT)
(Sheet 7 of 7)
LOCATION/ITEM
ACTION
REMARKS
NOTE
Apply a liquid detergent solution to tiont and
rear bead areas on tire.
Use self-attaching type air chuck with valve core
9. Valve stem
remove. After seal is made, install valve core.
Stad to one side of the - not in front d rim
area - when inflating tire.
You may have to compress tire, using chains and
b. Inflate tire to 70 psi front, 40 psi rear.
cable hoist, to get beads to seal.
c. Install valve cap.
Raise with hydraulic jack, remove wood Mocks
10. Axle housing
and lower titil tire rests on ground.
Disconnect.
11. Shipping link
END
Change 1