TM 10-3930-641-20
(Sheet 2 of 3)
CONTROLS AND LINKAGE ADJUSTMENT (CONT)
REMARKS
ACTION
LOCATION/ITEM
Remove.
1. Cotter pin (1) and washer (2)
Remove.
2. Pin (3)
Slide up on cable.
Loosen.
3. Nut (4)
Remove.
4. Yoke (5)
Pull spool to end of travel and release. Push spool to
Center. (Allow spool to slide to NEUTRAL
5. Spool
end of travel and release.
position.)
Adjust yoke (5) until retaining pin (3) can
6. Yoke (5)
be installed in holes without removing spool.
Install on threads and turn until it is flush
7. Nut (5)
with face of yoke.
Go on to Sheet 3
2-498