TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING SPECIFICATIONS (CONT)
(Sheet 2 of 2)
(8) Install bearing end with sharp corner even with surface. Notch
must be in position shown in view CC.
(9) Distance from end of bearing to surface of
housing ...........................................................................1.12 in. (28.4 mm)
(10) Distance from end of bearing to face of boss
on housing ............................................2.975 .020 in. (73.03 0.51 mm)
(11) Distance between the bearings for
the shaft.................................................1.370 020 in. (34.80 0.51 mm)
(12) Install pin until pin contacts bottom of housing.
TA098841
End
2-111
