TM 10-3930-641-34-1
STEERING CYLINDER AND MOUNTING SPECIFICATIONS
(Sheet 1 of 1)
(1)
on threads
1600 160 lb. ft. (2180 i 218 N.m)
(2)
Bore in new cylinder
5.00 + .005 or - .002 (127.00 + 0.13
or - 0.05 mm)
(3)
Bore in new head
2.254 .002 in. (57.25 + 0.05 mm)
Diameter of new rod .
2.2480 i .0015 in. (57.099 i 0.038 mm)
(4)
To get the correct torque on bolts (four places):
(a) Tighten bolts to
265 35 lb. ft. (360 i 48 N-m)
(b) Hit the joint (connection) with a hammer until
the torque goes below
140 lb. ft. (190 N-m)
(c) Tighten bolts to
265 35 lb. ft. (360 + 48 N.m)
(d) Hit the joint (connection) with a hammer until
the torque goes below
210 lb. ft. (286 N-m)
(e) Final torque for bolts
(two)
265 35 lb. ft. (360 48 N-m)
NOTE
Install the pin so that the groove on the end of the pin is
parallel ( 100) with the cylinder.
TA098862
2-132