TM 10-3930-641-34-1
FUEL TRANSFER PUMP DISASSEMBLY AND ASSEMEBLY (CONT)
(Sheet 5 of 6)
LOCATION/ITEM
ACTION
REMARKS
5. Bearing (17)
Install in body (14) so that it is flush with
surface of pump body.
a. Heat to no more than 600F (316C).
6. Gear (25)
b. Install on shaft (24) until dimension X is
1.947-1.967 in. (49.46-49.96 mm).
7. Driveshaft and gear (24)
a. Install in body (14).
b. Tighten nut to a torque of 17-27 lb. ft.
(24-36 N m).
8. Idler gear (23)
Install in body (14).
9. Lip type seal (8)
Install with seal driver until it is 0.13-0.17 in.
3.3-4.3 mm) below surface of cover (9) with
lip toward inside.
10. Plunger (5), spring (4), seal (3) and
a. Install in cover (9).
plug (2)
b. Tighten plug to a torque of 24-30 lb. ft.
(32-40 N m).
Go on to Sheet 6
3-62
