TM 10-3930-641-34-1
THROTTLE CONTROL (GOVERNOR PEDAL) REMOVAL/INSTALLATION (CONT)
(Sheet 5 of 7)
LOCATION/ITEM
ACTION
REMARKS
3.
Cable housing (3)
Install on cable with nut (4) and cable
coupler (5).
4.
Coupler (5)
Connect to plunger (6).
5.
Cable housing (3)
Install in linkage housing.
NOTE
If the hole in the cable housing is not in
alignment with the groove in the cable,
then remove the cable housing and
adjust the coupler on the cable. Tighten
the nut on the cable and again connect
the coupler to the plunger and install the
cable housing.
6.
Capscrew (7)
Install through cable housing (3) and install
nut.
NOTE
Bolt (7) must go through groove in the cable.
Go on to Sheet 6
3-99
