TM 10-3930-641-34-1
STARTER MOTOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 8 of 13)
LOCATION/ITEM
ACTION
REMARKS
4. Lever housing assembly (36)
If a new bushing (7) was installed it will have
DETAIL
to be reamed to an inside diameter of
0.8335-0.8355 in. (21.117-21.222 mm).
1. Wick
Install the oil saturated wick (1), pipe plug (2),
2. Pipe plug
felt plug (4), retaining plug (3) and new oil seal
3. Retaining plug
(5) in the lever housing (36).
4. Felt plug
5. Oil seal
Lever shaft (28)
Grease the oil seals (5) and install on the
7. Bushing
lever shaft (28). Grease the contact points of
36. Lever housing
the shift lever (30). Install the shift lever and
shaft in the housing (36) using the snap ring
(16) to hold the shaft in position.
DETAIL
17. Snap ring
28. Shaft
30. Shift lever
31, 32. O-ring
36. Lever housing
TA 099063
Go on to Sheet 9
3-194
