TM 10-3930-641-34-1
STARTER MOTOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 11 of 13)
LOCATION/ITEM
ACTION
REMARKS
9. Drive housing (24)
If a new bushing (3) was installed, ream it
DETAILS
to 0.6240-0.6260 in. (15.84960-15.9000
mm).
1. Rubber plug
3. Bushing
Install the oiled wick (7), pipe plug (6) felt
4. Felt plug
plug (4), retaining plug (5) and the rubber
5. Retaining plug
plug (1).
6. Pipe plug
7. Wick
10. Lever housing assembly (36)
While inserting the plunger into the switch,
24. Housing
mount the lever housing to the frame using
the screws and washers.
11. Drive assembly
Install the thrust washers thru the drive
assembly in the lever housing (36) using
grease on the contact areas.
Make sure the shift lever (30) engages.
TA 099066
Go on to Sheet 12
3-197