TM 10-3930-641-34-1
STARTER MOTOR TESTING (CONT)
(Sheet 2 of 6)
LOCATION/ITEM
ACTION
REMARKS
INSPECTION/REPAIR
1. All parts
Clean, then visually check all parts for
Replace as needed.
damaged or worn conditions. Replace all
gaskets and seals.
2. Drive housing (24)
If the sleeve inside diameter is not
Use a press for replacement.
0.624-0.626 in. (15.850-15.900 mm)
it must be replaced. Check the wick.
Check rubber plug, expansion plug, pipe
Replace as needed.
plug, gasket and wick.
3. Drive assembly (27)
Visually check for damage.
Replace as a unit.
4. Lever housing (36)
If sleeve inside diameter is not 0.8335-
Use a press for replacement. Discard old seals
0.8355 in. (2.1171-2.1222 mm)
and gaskets.
replace the sleeve.
5. Shift lever (30)
If lever bore inside diameter is not
0.5100--0.5120 in. (12.9540-13.004 mm)
it should be replaced.
6. Lever shaft (28)
If shaft diameter is not 0.4980-0.5000 in.
(12.540-12.7000 mm) it should be
replaced.
Go on to Sheet 3
3-201
