TM 10-3930-641-34-1
ROCKER SHAFT REMOVAL/INSTALLATION (CONT)
(Sheet 3 of 4)
LOCATION/ITEM
ACTION
REMARKS
2. Rocker shaft capscrews
a. Coat threads with clean oil.
b. Tighten capscrews in lettered sequence
shown at right. Torque in three steps:
Step 1: 200 + 20 lb. ft. (271.2 + 27.1 N m)
Step 2: 330 + 15 lb. ft. (447.4 + 20.3 N-m)
Step 3: 330 + 15 lb. ft. (447.4 + 20.3 N-m)
3. O-ring seal (6)
Coat with clean engine oil.
4. Spacers, fuel line adapters (7)
Install.
5. Locks (8)
Install.
TA099070
Go on to Sheet 4
3-209