TM 10-3930-641-34-1
TIMING GEARS REMOVAL/INSTALLATION (CONT)
(Sheet 5 of 6)
LOCATION/ITEM
ACTION
REMARKS
5.
Two eyebolts, 3/8-16 NC
Install in flywheel housing.
6.
Hoist
Fasten to flywheel housing.
7.
Flywheel housing
Put in position.
NOTE
Use plug hole (1) to visually aline the "V"
marks on the balancer gear and the crank-
shaft rear gear with cylinder number one
at top center.
8.
Seal Pilot
Remove.
9.
Twenty-one flywheel housing cap-
Install.
screws (3)
10.
Plug (2)
Install.
11.
Oil line
Install.
Go on to Sheet 6
3-313