TM10-3930-641-34-2
FRONT DIFFERENTIAL AND BEVEL GEAR INSTALLATION (CONT)
(Sheet 2 of 4)
LOCATION/ITEM
ACTION
REMARKS
1.
Differential and bevel gear (1)
a. Fasten to transmission floor jack (2).
NOTE
Put a piece of bar stock between bottom of
carrier assembly and surface of floor jack.
This
will keep carrier assembly off floor jack for
easier installation on to axle housing.
b.
Install preformed packing in groove on
differential carrier.
c.
Raise differential and bevel gear until the
unit aligns with axle housing as shown.
d.
Make sure that hole in carrier assembly is in
alignment with pin (3).
e.
Push unit into axle housing.
f.
Install the twenty-four capscrews that
secure differential and bevel gear to axle
housing.
g.
Remove floor jack.
TA099398
Go on to Sheet 3
4-247
