TM 10-3930-641-34-2
DRIVE AXLES REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 4)
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
1. Capscrew (1)
Remove from cover. Install a 1/2-13NC
4.6 in. (10-14 cm) long guide pin in bolt
hole.
2. Remaining five capscrews (1)
Remove.
3. Three capscrews (2)
Use as forcing bolts to loosen cover (3).
NOTE
Weight of cover is 40 lb. (18 Kg).
4. Cover and seal
Remove.
5. 7/16 NC forged eyebolt (4)
a. Install in end of axle.
b. Pull axle out of housing until a hoist
can be attached.
6. Axle (5)
Remove.
NOTE
Weight of axle is 135 lb. (61.2 Kg).
TA099400
Go on to Sheet 3
4-251