TM10-3930-641-34-2
PARKING BRAKE ASSEMBLY (CONT)
(Sheet 2 of 4)
LOCATION/ITEM
ACTION
REMARKS
1.
Parking brake cage (20)
Place on two wood blocks.
2.
Bearing (24)
Install in cage (20) until it makes contact with
counterbore.
3.
Ring (25)
Install ring that holds bearing in position.
4.
Lip type seal (23)
a.
Install in cage.
b. Install seal until it makes contact with
counterbore and with lip as shown.
5. Shaft (22) Install from bottom of cage.
6.
Hub (19)
Install over shaft.
7.
Preformed packing (9)
Install in end of shaft.
8.
Retainer (8)
Install capscrew that holds it. Tighten to a
torque of 80-90 lb. ft. (109-121 N-m).
9. Four disc assemblies (17) and
Install. Start with disc assembly and alternate
three plates (18)
a plate with a disc.
TA098944
Go on to Sheet 3
5-76
