TM10-3930-641-34-2
WHEEL BEARINGS ADJUSTMENT (CONT)
(Sheet 2 of6)
LOCATION/ITEM
ACTION
REMARKS
NOTE
ADJUSTMENT PROCEDURE
These adjustments start with sections of the
(OFF THE VEHICLE)
equipment off the vehicle.
1.
Spindle housing (7)
Place on a support with small end up.
2.
Brake group (6), bearings, wheel
Assemble on spindle housing (7).
assembly (1), and hub (5)
3.
Ring (3)
Install without shims (4).
4.
Capscrews (2)
Install five so that there are even spaces
between them.
5.
Wheel assembly (1)
While turning by hand torque capscrews (2)
to 55 to 75 lb.
ft. (76 to 104 N-m).
6.
Capscrews (2) and ring (3)
Remove.
7.
Distance between end of spindle
Measure at three different locations and find
To find average add the three distances and divide the
housing (7) and hub (5).
the average.
sum by three.
Go on to Sheet 3
5-92
