TM 10-3930-641-34-2
WHEEL BEARINGS ADJUSTMENT (CONT)
(Sheet 5 of 6)
LOCATION/ITEM
ACTION
REMARKS
5.
Depth micrometer (9)
Measure through the small holes in ring (3).
Average depth equals the sum of the three
Find the average depth.
measurements divided by three.
6.
Outside micrometer (10)
a. Measure through the small holes in ring (3).
Find the average depth.
b. Find the difference of the two average
measurements. The difference is the gap
between the end of the spindle housing
(7) and the ring (3).
7.
Ring (3)
Remove. Install enough shims (4) to be .001 in.
(0.03 mm) less than the gap found in step 6.
8.
Ring (3) and capscrews (2)
Install. Tighten capscrews evenly to a torque of
180 to 220 lb. ft. (245 to 295 N-m).
Go on to Sheet 6
5-95
