TM 10-3930-641-34-2
STEERING CYLINDERS REMOVAL/INSTALLATION (CONT)
(Sheet 5 of 6)
LOCATION/ITEM
ACTION
REMARKS
3.
Washer and capscrew
Install in retaining pin at cylinder end, but d
not tighten.
4.
Lubrication line (4)
Install. See sheet 3.
5.
Hydraulic lines at steering cylinder
Connect.
6.
Vehicle
Start engine and turn steering wheel until roc
end pin can be installed.
7.
Washer (1) and capscrew (2)
Install in retaining pin at rod end.
8.
Capscrews at rod end and cylinder
Tighten as follows:
end
a. Tighten to a torque of 230 lb. ft. to 300
lb. ft. (311.8-406.7 N-m).
b. Hit tapered ends of pins with a hammer
until torque is less than 140 lb. ft.
(189.8 Nm).
Go on to Sheet 6
6-83